Plastiform F85 Replicating Compounds

SKU: CA-F85-2
£65.00 Ex. Vat
£65.00

The F85 is extremely fluid, it is very easy to insert into the parts or cavities to be inspected. It produces a rigid final impression (85 Shore A hardness), therefore non-flexible. It cannot deform and does not accept any stress or elongation during the demoulding operation.

This plastiform can therefore only be used if you want to control simple shapes, without any Extraction Stress. The product does not tolerate any extraction stress: 0%.

The F85 is specifically designed to facilitate the control of simple shapes. Its rigidity allows them to be controlled with contact. This practice is not recommended with other plastiforms but is practicable on F85. If you do not have a visual inspection instrument and want to check simple shapes, the F85 is probably your best choice.

Finally, this Plastiform is also a very good mechanical reinforcement product. Thanks to its versatile rigidity, it strengthens the part and is flexible enough to absorb some of the vibrations

Technical Specs

Micron Accuracy

Plastiform F85 is accurate to 1 Micron

Simple Internal

F85 cannot deform and can therefore only be used if you want to control simple shapes

1 Minute

Cure time of 1 Minute at 20 Degrees, F85 is one of the fasting curing products.

85 Shore A

Final hardness of 85 Shore A, meaning a Rigid Product

Cannot be Sliced

Plastiform F85 is too rigid to be sliced, measurements should be taken visually or optically of the whole impression

50ml Cartridge

F85 is supplied in 50ml Cartridges for use with the nozzle based system.

Fluid

The F85 is extremely fluid, it is very easy to insert into the parts or cavities to be inspected

Grey

F85 is can be identified with its Grey colour

You May Also Like