Plastiform F20 Replicating Compounds

SKU: CA-F20-2
£60.00 Ex. Vat
£60.00

Thanks to its high initial Fluidity (flowable product), the F20 can easily infiltrate into any type of part, whether small (diameter up to 0.1 mm) or medium size.

The final impression is very flexible (hardness estimated at 20 Shore A), which allows it to be strongly stretched and deformed during de-moulding without any problem.

The F20 is therefore recommended for taking impressions in complex internal forms (threads, grooves and internal grooves…). However, it is important that the Extraction Constraint does not exceed 30%.

The impression is very accurate. All surface details (shape, dimension, appearance, surface condition, etc.) are reproduced in µm.

The replica is not altered during the extraction step, which allows for an optimal result. Similarly, it will not leave any trace of its passage through the controlled area.

Finally, the technical characteristics of the product also allow it to be used for protection. It is particularly effective in replacing a gasket.

Technical Specs

Micron Accuracy

Plastiform F20 is accurate to 1 Micron

Complex Internal

Designed to be used in Complex Internal Forms

8 Minutes

Cure time of 8 Mins at 20 Degrees

20 Shore A

Final hardness of 20 Shore A, meaning a Very Flexible Product

Cannot be Sliced

Plastiform F20 is too flexible to be sliced, measurements should be taken visually or optically of the whole impression

50ml Cartridge

F20 is supplied in 50ml Cartridges for use with the nozzle based system.

Fluid

As a fluid product F20 is very searching and ideal for complex internal Bores

Green

F20 is one of the most common products and can be identified with its Green colour

You May Also Like